Delivery & Installation

Requirements:

• • 110/120V grounded 3 prong electrical outlet must be within reach of the power cord.Your existing water lines will not be reused.

  • A new waterline connection kit will be added to your order at no additional cost.

  • For icemaker or ice and water dispenser connections, a working shut off valve must be located within 6 ft. of the refrigerator location and on the same floor.

  • Proper air clearance is required per brand specifications. To determine the clearance you'll need, review the product specs & details or owner's manual on the product page.

  • If a shut off valve, accessible drain, or proper space is not available, your installation may not be completed.

  • If the installation instructions for the refrigerator requires an anti-tip bracket, the delivery agents are required to install it.

Requirements:

• • Your existing connection parts will not be reused. A new electric cord will be added to your order at no additional cost.
    
    
  • 240 Volt electrical service is required to power units. Delivery agents cannot direct wire electric ranges. The outlet must be available at time of delivery and within 4ft of the appliance. Approved outlets shown below:
    
    
    
    
  • If the installation instructions for the range requires an anti-tip bracket, the delivery agents are required to install it.

Requirements:

• • Your existing connection parts will not be reused. A new gas flex connection kit will be added to your order at no additional cost.

  • A natural gas supply line (no L.P. hookups) with a functioning shut off valve must be located directly behind the appliance.

  • 110/120V grounded 3 prong electrical outlet must be within reach of the power cord.

  • If the shut off valve, accessible drain, or proper space is not available, your installation may not be completed.

  • If the installation instructions for the range requires an anti-tip bracket, the delivery agents are required to install it.

  • Some state and local codes prohibit installation hookup. When purchasing on our site, the installation availability in your area will be displayed.

  • Delivery agents will not convert to Liquid propane (LP).

Requirements:

• • The installation requires that the appliance be hard-wired (direct-wired) into an approved junction box. A plug and receptacle is NOT permitted on these products.

  • A 240V outlet must be supplied and contain the following: proper voltage, frequency, connected to an individual, properly grounded branch circuit, and protected by a circuit breaker or fuse.

Requirements:

• • 110/120V grounded 3 prong electrical outlet must be within reach of the power cord. Hardwiring will not be done.

  • The bottom edge of the cabinet must be at least 30" from the cooking surface.

  • Delivery agents will not drill through tile/granite/solid surfaces.

Requirements:

• • Your existing connection parts will not be reused. A new dishwasher connection kit will be added to your order at no additional cost.

  • A water supply line with a shut off valve must be located under the sink or behind the dishwasher. Note: the shut-off valve must be corrosion free and in good working condition.

  • An electrical outlet must be within 4ft of install location on the same side of the wall and on the same floor.

  • The cutout opening dimensions must be cut to brand specifications. To determine the cutout opening dimensions you'll need,review the product specs & details or owner's manual on the product page.

  • If the shut off, accessible drain, or proper space is not available, your installation may not be completed.

  • Some state and local codes prohibit installation hookup. When purchasing on our site, the installation availability in your area will be displayed.

Requirements:

• • Your existing hoses will not be reused. A new set of supply hoses will be added to your order at no additional cost.

  • 110/120V grounded 3 prong electrical outlet must be within reach of the power cord.

  • Water valves (hot & cold hookups) must be within 4 ft. of installation location and on the same floor. Note: the shut-off valve must be corrosion free and in good working condition. Test to ensure your valves can be shut off.

  • If proper shut off, accessible drain, or proper space is not available, your installation may not be complete.

  • Existing appliance must be empty with no standing water prior to delivery.

  • Select washers and dryers can be stacked as part of the installation. A stacking kit must be purchased separately. The applicable kit is listed under the related parts and accessories on the product page.

Requirements:

• • Your existing connection parts will not be reused. A new electric cord and dryer duct will be added to your order at no additional cost.

  • 240 Volt electrical service is required to power units.

  • An appropriate outlet must be available at time of delivery and within 6ft of the appliance (see approved outlets below). Delivery agents cannot direct wire electric dryers. Approved outlets shown below:
    
    

  • Semi rigid dryer duct is required to be connected to rigid external ducting.

  • Select washers and dryers can be stacked as part of the installation. A stacking kit must be purchased separately. The applicable kit is listed under the related parts and accessories on the product page.